• This means that toner is adhering to the white areas of the printout.
initial check
Are any parts being used that have incorrect specifications, or that are installed incorrectly, damaged, bent, dirty or that have foreign particles adhering to them?
Related parts
The following parts are related to this problem. There may be a problem with one of these parts, so if the problem cannot be solved by following this FIP, replace the following parts
one by one and check.
BTR Assy (PL9.1.2), ROS Assy (PL11.1.1), HVPS Sub (PL12.1.9) and PWB Controller (PL16.1.5)