• This means that the image is printed at an angle.
initial check
Are any parts being used that have incorrect specifications, or that are installed incorrectly, damaged, bent, dirty or that have foreign particles adhering to them?
Related parts
The following parts are related to this problem. There may be a problem with one of these parts, so if the problem cannot be solved by following this FIP, replace the following parts
one by one and check.
PAPER FEEDER, Chute Assy Regi (PL10.1.1), Chute Assy Out (PL7.1.1), BTR Assy (PL9.1.2) and Fuser Assy (PL9.1.1)
Item
Paper setting/Cassette Assy (PL2.1.4)
1. Remove the Cassette Assy where the problem occurred.
1
2. Reinsert the paper.
3. Reprint the page that caused the problem.
Does the problem still occur?
Paper feed path
2
Check if there are any problems such as burring, foreign matter or dirt in the paper feed path.