Epson AcuLaser C4000 Service Manual page 434

EPSON AcuLaser C4000/C4100/C3000
4.2.20.5 HARNESS ASSY FDR 2T (PL17.4.3) Removal
1. Remove the COVER FRONT. (See Section 4.2.20.1.)
2. Remove the COVER R (PL17.1.4). (See Section 4.2.20.2.)
3. Disconnect the connector (P/J821) of the SWITCH ASSY SIZE (PL17.2.7)
(TRAY 2).
Disconnect the connector (J82) on the PWBA FEEDER
C A U T I O N
(PL17.4.1) while holding the circuit board with your hand.
4. Disconnect the connector (P/J82) on the PWBA FEEDER.
5. Disconnect the relay connector (P/J8220) between the HARNESS ASSY
FDR2T and the HARNESS ASSY NPRSJ (PL17.4.11).
6. Disconnect the connector (P/J824) of the SOLENOID FEED (PL17.3.17)
(TRAY 2).
7. Disconnect the connector (P/J825) of the CLUTCH ASSY TURN
(PL17.3.18) (TRAY 2).
8. Disconnect the connector (P/J823) of the SENSOR LOW PAPER
(PL17.4.7) (TRAY 2).
9. Remove the HARNESS ASSY FDR 2T from the 6 CLAMPs.
See the illustration for details on the installation of the
HARNESS ASSY FDR 2T (gray) connector and routing of the
harness.
Disassembly and Assembly
Figure 4-122. HARNESS ASSY FDR 2T (PL17.4.3) Removal
Disassembly Assembly Procedures
Revision F
4-419