Front Panel(S) Installation; Front Panel(S) Installation With Rear Hard Top Removed; Rear Hard Top Removal - Jeep 2013 Wrangler Owner's Manual

Front Panel(s) Installation

NOTE:
Set the panels on the windshield frame so
that there is no overhang. Also, make sure
that the panels are sitting flush with the
body.
1. Install the right panel first, then the left panel.
2. Reinstall the panel(s) using the same steps
for removal in reverse order.
PAGE POSITION: 113 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
Front Panel(s) Installation With Rear
Hard Top Removed
1. Turn the left and right panels over and move
the spacer block (located on the rear of the
panel) upward 90 degrees.
NOTE:
The front panel(s) must be positioned prop-
erly to ensure sealing. Set the panels on the
windshield frame so that there is no over-
hang. Also, make sure that the panels are
sitting flush with the body.
2. Install the right panel first, then the left panel.
3. Reinstall the panel(s) using the same steps
for removal in reverse order.

Rear Hard Top Removal

1. Remove both front panels. Refer to "Front
Panel(s) Removal" in this section.
2. Open both doors.
3. Remove the two Torx head screws that
secure the hard top at the B-pillar (near the top
of the door) using a #40 Torx
(Four–Door Only).
4. Remove the six Torx head screws that
secure the hard top to the vehicle (along the
interior bodyside) using a #40 Torx head driver.
head driver
111