Jeep 2013 Wrangler Owner's Manual page 72

except for pagers of certain companies, which
time out a little too soon to work properly with
the Uconnect Phone.
Voice Mail Calling
To learn how to access your voice mail, refer to
"Working with Automated Systems".
Working with Automated Systems
This method is used in instances where one
generally has to press numbers on the mobile
phone keypad while navigating through an au-
tomated telephone system.
You can use your Uconnect Phone to access a
voice mail system or an automated service,
such as a paging service or automated cus-
tomer service. Some services require immedi-
ate response selection. In some instances, that
may be too quick for use of the Uconnect
Phone.
When calling a number with your Uconnect
Phone that normally requires you to enter in a
touch-tone sequence on your mobile phone
keypad, you can press the
the sequence you wish to enter followed by the
word "Send". For example, if required to enter
your PIN followed with a pound, (3 7 4 6 #), you
70
PAGE POSITION: 72 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
can press the
Send". Saying a number, or sequence of num-
bers, followed by "Send", is also to be used for
navigating through an automated customer ser-
vice center menu structure, and to leave a
number on a pager.
You can also send stored Uconnect Phone-
book entries as tones for fast and easy access
to voice mail and pager entries. To use this
feature, dial the number you wish to call and
then press the
system will prompt you to enter the name or
number and say the name of the phonebook
entry you wish to send. The Uconnect Phone
will then send the corresponding phone number
associated with the phonebook entry, as tones
over the phone.
NOTE:
• You may not hear all of the tones due to
mobile phone network configurations;
this is normal.
• Some paging and voice mail systems
button and say
have system time out settings that are too
short and may not allow the use of this
feature.
button and say, "3 7 4 6 # Barge In - Overriding Prompts
The "Voice Command" button can be used
when you wish to skip part of a prompt and
issue your voice command immediately. For
example, if a prompt is asking "Would you like to
pair a phone, clear a...," you could press the
that option without having to listen to the rest of
the voice prompt.
Turning Confirmation Prompts On/Off
button and say "Send". The Turning confirmation prompts off will stop the
system from confirming your choices (e.g., the
Uconnect Phone will not repeat a phone num-
ber before you dial it).
• Press the
• After the "Ready" prompt and the following
Phone and Network Status Indicators
If available on the radio and/or on a premium
display such as the instrument panel cluster,
and supported by your mobile phone, the
Uconnect
button and say, "Pair a Phone" to select
button to begin.
beep, say:
• "Setup Confirmations Prompts On"
• "Setup Confirmations Prompts Off"
Phone will provide notification to