PAGE POSITION: 310 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1

Bulb Type

(Serviced at Authorized Dealer)

BULB REPLACEMENT

NOTE:

Lens fogging can occur under certain atmo-

spheric conditions. This will usually clear as

atmospheric conditions change to allow the

condensation to change back into a vapor.

Turning the lamps on will usually accelerate

the clearing process.

Headlamp

1. Open hood and support using prop rod.

2. Remove the front grille. Turn the retainers

along the top 1/4 turn counterclockwise and

remove.

3. Pull the bottom of the grille away starting at

one side and working toward the other.

4. Turn both park and turn signal socket as-

semblies 1/4 turn counterclockwise and re-

move.

5. Remove the four screws holding the metal

retaining ring.

6. Remove the lamp from the collar.

7. Remove the connector from the lamp, and

remove the rubber seal.

8. Unlatch the metal spring bulb retainer by

pushing forward and outward on retaining legs.

9. Pull the bulb from the housing.

10. Install the bulb into the headlamp housing.

CAUTION!

Do not touch the new bulb with your fingers.

Oil contamination will severely shorten bulb

life. If the bulb comes in contact with any oily

surface, clean the bulb with rubbing alcohol.

11. Latch the metal spring retainer to headlamp

bulb.

12. Install the rubber seal and connector to the

headlamp bulb.

13. Reinstall lamp to body with retaining ring

and four screws.

14. Reinstall park and turn signal connectors,

and reinstall front grille.

Table of Contents

Chapters

Table of Contents

Bulb Replacement; Headlamp - Jeep 2013 Wrangler Owner's Manual