To Lock The Doors And Swing Gate; To Turn Off Flash Lights With Lock; General Information - Jeep 2013 Wrangler Owner's Manual

2. Continue to hold the RKE transmitter LOCK
button for at least four seconds, but not longer
than 10 seconds, then press and hold the RKE
transmitter UNLOCK button.
3. Release both buttons at the same time.
4. Test this feature while outside of the vehicle
by pressing the LOCK/UNLOCK button on the
RKE transmitter.
NOTE:
Pressing the RKE transmitter LOCK button
while you are inside of the vehicle will acti-
vate the Vehicle Security Alarm. Opening a
door with the Vehicle Security Alarm acti-
vated will cause the alarm to sound. Press
the RKE transmitter UNLOCK button to de-
activate the Vehicle Security Alarm.
5. If the desired programming was not
achieved or to reactivate this feature, repeat the
above steps.
NOTE:
Pressing the LOCK button on the RKE trans-
mitter while you are inside the vehicle will
activate the Vehicle Security Alarm. Opening
a door with the Vehicle Security Alarm acti-
PAGE POSITION: 19 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
vated will cause the alarm to sound. Press
the UNLOCK button to deactivate the Ve-
hicle Security Alarm.

To Lock The Doors And Swing Gate

Press and release the LOCK button on the RKE
transmitter to lock all doors. The turn signals will
flash and the horn will chirp once to acknowl-
edge the lock signal.

To Turn Off Flash Lights With Lock

This feature will cause the turn signal lights to
flash when the doors are locked or unlocked
with the RKE transmitter. This feature can be
turned on or turned off. To change the current
setting, proceed as follows:
• For vehicles equipped with the EVIC, refer to
"Electronic Vehicle Information Center (EVIC)/
Personal Settings (Customer-Programmable
Features)" in "Understanding Your Instrument
Panel" for further information.
• For vehicles not equipped with the EVIC,
perform the following steps:
1. Press the RKE transmitter UNLOCK button
for 4 to 10 seconds.
2. While the UNLOCK button is pressed, (after
four seconds) press the RKE transmitter LOCK
button. Release both buttons.
3. Test the "Flash Lights With Lock" feature
outside of the vehicle by pressing the RKE
transmitter LOCK button with the ignition in the
LOCK position and the key removed.
NOTE:
Pressing the RKE transmitter LOCK button
while you are in the vehicle will activate the
Vehicle Security Alarm. Opening a door with
the Vehicle Security Alarm activated will
cause the alarm to sound. Press the RKE
transmitter UNLOCK button to deactivate
the Vehicle Security Alarm.
The "Flash Lights With Lock" feature can be
reactivated by repeating this procedure.

General Information

This device complies with Part 15 of FCC rules
and with RS-210 of Industry Canada. Operation
is subject to the following conditions:
1. This device may not cause harmful interfer-
ence.
17