Bluetooth Streaming Audio (Btsa) - Jeep 2013 Wrangler Owner's Manual

Hide thumbs Also See for 2013 Wrangler:
Table of Contents

Advertisement

• To exit List mode without selecting a track,
press the same PRESET button again to
go back to Play mode.
• LIST button: The LIST button will display the
top level menu of the iPod or external USB
device. Turn the TUNE control knob to list the
top-menu item to be selected and press the
TUNE control knob. This will display the next
sub-menu list item on the audio device, then
follow the same steps to go to the desired
track in that list. Not all iPod or external USB
device sub-menu levels are available on this
system.
• MUSIC TYPE button: The MUSIC TYPE
button is another shortcut button to the genre
listing on your audio device.
CAUTION!
• Leaving the iPod or external USB device
(or any supported device) anywhere in the
vehicle in extreme heat or cold can alter
the operation or damage the device. Fol-
low the device manufacturer's guidelines.
PAGE POSITION: 187 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
CAUTION! (Continued)
• Placing items on the iPod
USB device, or connections to the iPod or
external USB device in the vehicle, can
cause damage to the device and/or to the
connectors.
WARNING!
Do not plug in or remove the iPod
external USB device while driving. Failure to
follow this warning could result in an acci-
dent.

Bluetooth Streaming Audio (BTSA)

Music can be streamed from your cellular
phone to the Uconnect phone system.
Controlling BTSA Using Radio Buttons
To get into the BTSA mode, press either "AUX"
button on the radio or press the VR button and
say "Bluetooth Streaming Audio".
(Continued)
Play Mode
When switched to BTSA mode, some audio
or external
devices can start playing music over the vehi-
cle's audio system, but some devices require
the music to be initiated on the device first, then
it will get streamed to the Uconnect phone
system. Seven devices can be paired to the
Uconnect phone system, but just one can be
selected and played.
Selecting Different Audio Device
or
1. Press PHONE button to begin.
2. After the "Ready" prompt and the following
beep, say "Setup", then "Select Audio Devices".
3. Say the name of the audio device or ask the
Uconnect phone system to list audio devices.
Next Track
Use the SEEK UP button, or press the VR
button on the radio and say "Next Track" to jump
to the next track music on your cellular phone.
Previous Track
Use the SEEK DOWN button, or press the VR
button on the radio and say "Previous Track" to
jump to the previous track music on your cellular
phone.
185

Advertisement

Table of Contents
loading

Table of Contents