Jeep 2013 Wrangler Owner's Manual page 214

2. Shift the transmission into PARK.
3. Turn the ignition switch to the OFF position.
4. Wait approximately 10 seconds.
5. Restart the engine.
6. Shift into the desired gear range. If the
problem is no longer detected, the transmission
will return to normal operation.
NOTE:
Even if the transmission can be reset, we
recommend that you visit your authorized
dealer at your earliest possible conve-
nience. Your authorized dealer has diagnos-
tic equipment to determine if the problem
could recur. If the transmission cannot be
reset, authorized dealer service is required.
AUTOSTICK
AutoStick is a driver-interactive transmission
feature providing manual shift control, giving
you more control of the vehicle. AutoStick
allows you to maximize engine braking, elimi-
nate undesirable upshifts and downshifts, and
improve overall vehicle performance.
212
PAGE POSITION: 214 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
This system can also provide you with more
control during passing, city driving, cold slippery
conditions, mountain driving, trailer towing, and
many other situations.
NOTE:
AutoStick is not available when the trans-
fer case is in the 4L (Low) range. Instead,
Electronic Range Select (ERS) can be used
for manual shifting while in the 4L range
(refer to Electronic Range Select (ERS) Op-
eration in this section).
Operation
When the shift lever is in the DRIVE position,
the transmission will operate automatically,
shifting between the five available gears. To
engage AutoStick , simply tap the shift lever to
the right or left (+/-) while in the DRIVE position.
Tapping (-) to enter AutoStick mode will down-
shift the transmission to the next lower gear,
while using (+) to enter AutoStick mode will
retain the current gear. When AutoStick
active, the current transmission gear is dis-
played in the instrument cluster. In AutoStick
mode, the transmission will shift up or down
when (+/-) is manually selected by the driver,
unless an engine lugging or overspeed condi-
tion would result. It will remain in the selected
gear until another upshift or downshift is cho-
sen, except as described below.
• The transmission will automatically upshift
when necessary to prevent engine over-
speed.
• The transmission will automatically downshift
as the vehicle slows (to prevent engine lug-
ging) and will display the current gear.
• The transmission will automatically downshift
to first gear when coming to a stop. After a
stop, the driver should manually upshift (+)
the transmission as
accelerated.
• Heavily pressing the accelerator pedal will
generate an automatic downshift (for im-
proved acceleration) when reasonable.
• You can start out, from a stop, in first or
second gear. Tapping (+) (at a stop) will allow
is
starting in second gear. Starting out in sec-
ond gear is helpful in snowy or icy conditions.
the vehicle is