Things You Should Know About Your Uconnect Phone - Jeep 2013 Wrangler Owner's Manual

Select Another Mobile Phone
This feature allows you to select and start using
another phone paired with the Uconnect
Phone.
• Press the
• After the "Ready" prompt and the following
beep, say "Setup Select Phone" and follow
the prompts.
• You can also press the
time while the list is being played, and then
choose the phone that you wish to select.
• The selected phone will be used for the next
phone call. If the selected phone is not
available, the Uconnect Phone will return to
using the highest priority phone present in or
near (approximately within 30 ft [9 m]) the
vehicle.
Delete Uconnect Phone Paired Mobile
Phones
• Press the
• After the "Ready" prompt and the following
beep, say "Setup Phone Pairing".
72
PAGE POSITION: 74 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
button to begin.
button at any
button to begin.
• At the next prompt, say "Delete" and follow
the prompts.
• You can also press the
button at any
time while the list is being played, and then
choose the phone you wish to delete.
Things You Should Know About
Your Uconnect Phone
Uconnect Phone Tutorial
To hear a brief tutorial of the Uconnect Phone
features, press the button and say
"Uconnect Tutorial".
Voice Training
For users experiencing difficulty with the
Uconnect Phone recognizing their voice com-
mands or numbers, the Uconnect Phone Voice
Training feature may be used. To enter this
training mode, follow one of the two following
procedures:
From outside the Uconnect Phone mode (e.g.,
from radio mode)
• Press and hold the
button for five sec-
onds until the session begins, or,
• Press the
button and say the "Voice
Training", "System Training", "Start Voice
Training"command.
Repeat the words and phrases when prompted
by the Uconnect Phone. For best results, the
Voice Training session should be completed
when the vehicle is parked with the engine
running, all windows closed, and the blower fan
switched OFF.
This procedure may be repeated with a new
user. The system will adapt to the last trained
voice only.
To restore the Voice Command system to fac-
tory default settings, enter the Voice Training
session via the above procedure and follow the
prompts.
Voice Command
• For best performance, adjust the rearview
mirror to provide at least ½ in (1 cm) gap
between the overhead console (if equipped)
and the mirror.
• Always wait for the beep before speaking.