Average Fuel Economy; Distance To Empty (Dte); Elapsed Time; System Status - Jeep 2013 Wrangler Owner's Manual

To Change The Compass Variance:
1. Turn the ignition switch RUN (it is not nec-
essary to start the engine).
2. Press the MENU button until Personal Set-
tings (Customer-Programmable Features) dis-
plays in the EVIC.
3. Press the DOWN button until "Compass
Variance" message and the last variance zone
number displays in the EVIC.
4. Press and release the SELECT button until
the proper variance zone is selected according
to the map.
5. Press and release the COMPASS button to
exit.

Average Fuel Economy

Shows the average fuel economy since the last
reset. Average Fuel Economy can be reset by
pressing and holding the SELECT button (as
prompted in the EVIC display). Upon reset, the
history information will be erased, and the av-
eraging will continue from the last fuel average
reading before the reset.
180
PAGE POSITION: 182 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1

Distance To Empty (DTE)

Shows the estimated distance that can be trav-
eled with the fuel remaining in the tank. This
estimated distance is determined by a weighted
average of the instantaneous and average fuel
economy, according to the current fuel tank
level. DTE cannot be reset.
NOTE:
Significant changes in driving style or ve-
hicle loading will greatly affect the actual
drivable distance of the vehicle, regardless
of the DTE display value.
When the DTE value is less than 30 miles
(48 km) estimated driving distance, the DTE
display will change to a text display of "LOW
FUEL". This display will continue until the ve-
hicle runs out of fuel. Adding a significant
amount of fuel to the vehicle will turn off the
LOW FUEL text and a new DTE value will
display.

Elapsed Time

Shows the total elapsed time of travel since the
last reset. Elapsed time will increment when the
ignition switch is in the RUN or START position.
Elapsed time is displayed as follows:
hours:minutes:seconds
Elapsed time can be reset by pressing and
holding the SELECT button (as prompted in the
EVIC display). Upon reset all digits will change
to zeros and time will start incrementing again if
the ignition switch is in RUN or START.

System Status

Displays SYSTEM OK if there are no active
Warning Messages stored. Pressing and re-
leasing the DOWN button when SYSTEM OK is
displayed will do nothing. Displays SYSTEM
WARNINGS PRESENT if there are active
Warning Messages stored. Pressing and re-
leasing the DOWN button when SYSTEM
WARNINGS PRESENT is displayed will display
each stored warning for each button press.
Press and Release the MENU button to return
to the Main Menu.
Personal Settings (Customer-
Programmable Features)
Personal Settings allows the driver to set and
recall features when the vehicle speed is at