To Open And Close The Hood - Jeep 2013 Wrangler Owner's Manual

To Fold Down The Rear Seat
Locate the pull strap (lower outboard side of
seat), and pull it toward you until the seatback
releases.
To Raise The Rear Seat
Raise the seatback and lock it into place. If
interference from the cargo area prevents the
seatback from fully locking, you will have diffi-
culty returning the seat to its proper position.
88
PAGE POSITION: 90 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
NOTE:
If the rear seatback is not fully latched, the
center shoulder belt will not be able to be
extended for use. If you cannot extend the
center shoulder belt, make sure your seat-
back is fully latched.
Pull Strap
TO OPEN AND CLOSE THE
HOOD
Release both the hood latches.
WARNING!
Be certain that the seatback is securely
locked into position. If the seatback in not
securely locked into position the seat will not
provide the proper stability for child seats
and/or passengers. An improperly latched
seat could cause serious injury.
Hood Latch
Raise the hood and locate the safety latch,
located in the middle of the hood opening. Push
the latch to the left side of the vehicle, to open
the hood. You may have to push down slightly
on the hood before pushing the safety latch.
Insert the support rod into the slot on the hood.
To close the hood, remove the support rod from
the hood panel and place it in the retaining clip.
Lower the hood slowly. Secure both of the hood
latches.