Control Buttons; Compass/Temperature Display - Jeep 2013 Wrangler Owner's Manual

Compass Display

Control Buttons

The Compass/Temperature control buttons are
located on the left spoke of the steering wheel.
PAGE POSITION: 173 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
Press and release the STEP button on the
steering wheel to access the options in the
Compass display.
NOTE:
The system will display the last known out-
side temperature when starting the vehicle
and may need to be driven several minutes
before the updated temperature is dis-
played. Engine temperature can also affect
the displayed temperature; therefore, tem-
perature readings are not updated when the
vehicle is not moving.
Press and release the STEP button to step
through each of the following CMTC features:
• Compass / Outside Temperature
• AVG ECO (Average Fuel Economy)
• DTE (Distance to Empty)
• ET (Elapsed Time)
AVG ECO and ET can be reset. When the
feature is displayed, press and hold the RESET
button until the feature resets (about 2 sec-
onds).
These messages can be cycled through by
pressing the STEP button on the steering
wheel. To reset the AVG ECO or ET, press and
hold the STEP button for approximately three
seconds.

Compass/Temperature Display

NOTE:
If the vehicle is equipped with a Chrysler
Uconnect gps (Navigation Radio), the NAV
system will provide the compass direction,
and the variance and calibration menus will
be unavailable. The compass will perform
accurately, based on GPS signals instead of
the Earth's magnetic field.
Compass Variance
Compass Variance is the difference between
Magnetic North and Geographic North. To com-
pensate for the differences, the variance should
be set for the zone where the vehicle is driven,
per the zone map. Once properly set, the com-
pass will automatically compensate for the dif-
ferences and provide the most accurate com-
pass heading.
171