Front Park/Turn Signal; Front Side Marker; Front Fog Lamp; Rear Tail, Stop, Turn Signal, And Backup Lamp - Jeep 2013 Wrangler Owner's Manual

Front Park/Turn Signal

1. Remove the front grille. Turn the retainers
along the top 1/4 turn counterclockwise and
remove.
2. Pull the bottom of the grille away starting at
one side and working toward the other.
3. Turn the socket assembly 1/4 turn counter-
clockwise and remove from housing. Pull the
bulb straight from the socket to replace.

Front Side Marker

1. Reach under the front fender flare and locate
the front side marker socket.
2. Turn the socket assembly counterclockwise
1/3 turn and remove it from the housing. Pull the
bulb straight from the socket to replace.
PAGE POSITION: 311 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1

Front Fog Lamp

1. Reach under the vehicle to access the back
of the front fog lamp.
2. Disconnect the wire harness connector from
the front fog lamp connector receptacle.
3. Firmly grasp the bulb by the two latch fea-
tures and squeeze them together to unlock the
bulb from the back of the front fog lamp housing.
4. Pull the bulb straight out from the keyed
opening in the housing and then connect the
replacement bulb.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
Rear Tail, Stop, Turn Signal, And
Backup Lamp
1. Remove the two inboard screws attaching
the tail light housing to the body. DO NOT
REMOVE THE OUTER SCREWS AT ANY
TIME.
2. Separate the housing from the body by
pushing the lamp inboard while pulling the lamp
away from the body.
309