Jeep 2013 Wrangler Owner's Manual page 215

• The system will ignore attempts to upshift at
too low of a vehicle speed.
• Avoid using speed control when AutoStick
is engaged.
• Transmission shifting will be more noticeable
when AutoStick is engaged.
• To disengage AutoStick mode, hold the shift
lever to the right (+) until "D" is once again
displayed in the instrument cluster. You can
shift in or out of the AutoStick mode at any
time without taking your foot off the accelera-
tor pedal.
WARNING!
Do not downshift for additional engine brak-
ing on a slippery surface. The drive wheels
could lose their grip and the vehicle could
skid, causing an accident or personal injury.
PAGE POSITION: 215 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
Electronic Range Select (ERS) Operation
The Electronic Range Select (ERS) shift control
is only used when the transfer case is in the 4L
(Low) range. In the transfer case 2H and 4H
(High) positions, the AutoStick shift control is
available (refer to "AutoStick " in this section).
The Electronic Range Select (ERS) shift control
allows the driver to limit the highest available
gear when the transfer case is in the 4L (Low)
position, and the shift lever is in the DRIVE
position. For example, if you shift the transmis-
sion into 3 (third gear), the transmission will
never shift above third gear, but will shift down
into second and first gears normally.
You can switch between DRIVE and ERS mode
at any vehicle speed. When the shift lever is in
the DRIVE position, the transmission will oper-
ate automatically, shifting between all available
gears. Tapping the shift lever to the left (-) will
downshift the transmission, activate ERS mode,
display the current gear in the instrument clus-
ter, and maintain that gear as the top available
gear. Once in ERS mode, tapping the shift lever
to the left (-) or right (+) will change the top
available gear.
To exit ERS mode, simply press and hold the
shift lever to the right (+) until "D" is once again
displayed in the shift lever position indicator in
the instrument cluster.
WARNING!
Do not downshift for additional engine brak-
ing on a slippery surface. The drive wheels
could lose their grip and the vehicle could
skid, causing an accident or personal injury.
Screen Display 1 2 3
Actual Gear(s) 1 1-2 1-3 1-4
Allowed
NOTE:
To select the proper gear position for maxi-
mum deceleration (engine braking), tap the
shift lever to the left (-) repeatedly as the
vehicle slows. The transmission will shift to
the range from which the vehicle can best be
slowed down.
4 D
1-5
213