Jeep 2013 Wrangler Owner's Manual page 147

6. Ensure that the top locks into the Sunrider
locking mechanisms that are located above the
front of the rear doors.
7. Unclip and move the sun visors to the side.
8. Standing on the side of the vehicle, lift the
top by the side bow until it rests on the wind-
shield frame.
PAGE POSITION: 147 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
9. Open the header latches and engage the
hook on each side onto the windshield loops (do
not close the latches).
10. If the swing gate brackets were removed,
install them by hooking the rear edge of the
bracket on the interior side of the body channel.
Then, rotate it rearward and over the channel
until it snaps onto the exterior part of the rail. To
be properly located, the bracket must only be
clipped to the shortened rail edge.
11. Ensure that the straps are positioned cor-
rectly before pulling the sail panels over the rear
roof bow (4–bow).
145