Body Lubrication - Jeep 2013 Wrangler Owner's Manual

turer recommends that air conditioning service
be performed by authorized dealer or other
service facilities using recovery and recycling
equipment.
NOTE:
Use only manufacturer approved A/C sys-
tem sealers, stop leak products, seal condi-
tioners, compressor oil, and refrigerants.
A/C Air Filter
WARNING!
Do not remove the A/C air filter while the
blower is operating or personal injury may
result.
The A/C air filter is located in the fresh air inlet
behind the glove box. Perform the following
procedure to replace the filter:
1. Open the glove compartment and remove all
contents.
2. Push in on the sides of the glove compart-
ment and lower the door.
3. Pivot the glove compartment downward.
288
PAGE POSITION: 290 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
4. Disengage the two retaining tabs that secure
the two air filter access doors to the HVAC
housing.
5. Open the two air filter access doors.
6. Remove the two particulate air filters from
the HVAC air inlet housing. Pull the filter ele-
ments straight out of the housing, one at a time.
7. Install the A/C air filter with the air filter
position indicators pointing in the same direc-
tion as removal.
CAUTION!
The A/C air filter is identified with an arrow to
indicate airflow direction through the filter.
Failure to properly install the filter will result
in the need to replace it more often.
8. Rotate the glove compartment door back
into position.
Refer to the "Maintenance Schedule" for the
proper maintenance intervals.

Body Lubrication

Locks and all body pivot points, including such
items as seat tracks, door hinge pivot points
and rollers, liftgate, tailgate, sliding doors and
hood hinges, should be lubricated periodically
with a lithium based grease, such as MOPAR