Jeep 2013 Wrangler Owner's Manual page 44

Hide thumbs Also See for 2013 Wrangler:
Table of Contents

Advertisement

return to the retractor, pulling on the excess
webbing to tighten the lap portion around the
child restraint. For additional information, re-
fer to "Automatic Locking Mode".
• In the rear seat, you may have trouble tight-
ening the lap/shoulder belt on the child re-
straint because the buckle or latch plate is
too close to the belt path opening on the
restraint. Disconnect the latch plate from the
buckle and twist the short buckle-end belt
several times to shorten it. Insert the latch
plate into the buckle with the release button
facing out.
• If the belt still cannot be tightened, or if
pulling and pushing on the restraint loosens
the belt, disconnect the latch plate from the
buckle, turn the buckle around, and insert the
latch plate into the buckle again. If you still
cannot make the child restraint secure, try a
different seating position.
• Buckle the child into the restraint exactly as
the manufacturer's instructions tell you.
42
PAGE POSITION: 44 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
WARNING!
When your child restraint is not in use,
secure it in the vehicle with the seat belt or
remove it from the vehicle. Do not leave it
loose in the vehicle. In a sudden stop or
collision, it could strike the occupants or
seatbacks and cause serious personal injury.
Older Children And Child Restraints
Children who are two years old or who have
outgrown their rear-facing convertible child seat
can ride forward-facing in the vehicle. Forward-
facing child seats and convertible child seats
used in the forward-facing direction are for
children who are over two years old or who have
outgrown the rear-facing weight or height limit
of their rear-facing convertible child seat. Chil-
dren should remain in a forward-facing child
seat with a harness for as long as possible, up
to the highest weight or height allowed by the
child seat. These child seats are also held in the
vehicle by the lap/shoulder belt or the ISOFIX
child restraint anchorage system. Refer to "ISO-
FIX — Child Seat Anchorage System".
All children whose weight or height is above the
forward-facing limit for the child seat should use
a belt-positioning booster seat until the vehicle's
seat belts fit properly. If the child cannot sit with
knees bent over the vehicle's seat cushion
while the child's back is against the seatback,
they should use a belt-positioning booster seat.
The child and belt-positioning booster seat are
held in the vehicle by the lap/shoulder belt.
Children Too Large For Booster Seats
Children who are large enough to wear the
shoulder belt comfortably, and whose legs are
long enough to bend over the front of the seat
when their back is against the seatback, should
use the lap/shoulder belt in a rear seat.
• Make sure that the child is upright in the seat.
• The lap portion should be low on the hips and
as snug as possible.
• Check belt fit periodically. A child's squirming
or slouching can move the belt out of
position.

Advertisement

Table of Contents
loading

Table of Contents