Vehicle Security Alarm - If Equipped; Rearming Of The System; To Arm The System; To Disarm The System - Jeep 2013 Wrangler Owner's Manual

• This device must accept any interference
that may be received, including interference
that may cause undesired operation.
VEHICLE SECURITY ALARM —
IF EQUIPPED
The Vehicle Security Alarm monitors the vehicle
doors, hood, swing gate, and ignition for unau-
thorized operation.
If something triggers the alarm, the Vehicle
Security Alarm will sound the horn intermittently,
the headlights will turn on, flash the turn signal
lights, and flash the Vehicle Security Light in the
cluster.

Rearming Of The System

If something triggers the alarm, and no action is
taken to disarm it, the Vehicle Security Alarm
will turn off the horn after 29 seconds, and turn
off all of the visual signals after an additional 31
seconds, then the Vehicle Security Alarm will
rearm itself.
PAGE POSITION: 17 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1

To Arm The System

1. Remove the key from the ignition switch and
exit the vehicle.
2. Lock the doors and swing gate by pressing
the power door LOCK switch or the LOCK
button on the Remote Keyless Entry (RKE)
transmitter.
NOTE:
The Vehicle Security Alarm will not arm if
you lock the doors with the manual door
lock plungers or the driver's door lock cyl-
inder.
3. Close all the doors.
The Vehicle Security Light in the instrument
cluster will flash rapidly for about 16 seconds to
signal that the Vehicle Security Alarm is arming.
During this period, opening any door or the
swing gate will cancel the arming process. If the
Vehicle Security Alarm is successfully set, the
Vehicle Security Light will flash at a slower rate
to indicate the alarm is armed.

To Disarm The System

Either press the UNLOCK button on the RKE
transmitter or insert a valid Sentry Key into the
ignition lock cylinder and turn the key to the
ON/RUN position.
NOTE:
• Unlocking the doors with the manual door
lock plungers or the driver's door lock
cylinder will not disarm the Vehicle Secu-
rity Alarm.
• When the Vehicle Security Alarm is
armed, the interior power door lock
switches will not unlock the doors.
The Vehicle Security Alarm is designed to pro-
tect your vehicle; however, you can create
conditions where the Vehicle Security Alarm will
give you a false alarm. If the previously de-
scribed arming sequence has occurred, the
Vehicle Security Alarm will arm regardless of
whether you are inside or outside the vehicle. If
you remain inside the vehicle and open a door,
the alarm will sound. If this occurs, disarm the
Vehicle Security Alarm.
15