Rear Master Cylinder Removal - Honda CBR954RR 2002 Service Manual

Place the master cylinder assembly on the handlebar.
Align the end of the master cylinder w i t h the punch
mark on the handlebar.
Install the master cylinder holder with the "UP" mark
facing up.
Tighten the upper bolt first, then the lower bolt.
Install the brake hose eyelet with the oil bolt and new
sealing washers.
Push the eyelet joint against the stopper, then tighten
the oil bolt t o the specified torque.
TORQUE: 34 N-m (3.5 kgf-m, 25 Ibf-ft)
Connect the brake light switch wire connectors.
Fill the reservoir t o the upper level and bleed the
brake system (page 15-5).
REAR MASTER CYLINDER
REMOVAL
Drain the rear hydraulic system (page 15-4).
Remove the rear master cylinder reservoir mounting
bolt.
Avoid spiiiing fluid Remove the brake hose
brake hose.
on painted, P/aSfiC,
or rubber parts
Loosen the rear master cylinder mounting bolts.
these parts when-
Remove the main footpeg bracket socket bolts and
ever the system
main footpeg bracket assembly.
is serviced
Release the
behind the right step guard.
oil
bolt, sealing washers and
sensor wire from the wire guide
0 2
HYDRAULIC BRAKE