Oil Pressure Switch Inspection; Oil Pressure Switch Removal/Installation - Honda CBR954RR 2002 Service Manual

OIL PRESSURE SWITCH
I NSPECTI 0 N
If the oil pressure warning indicator stays on while the
engine is running, check the engine oil level before
inspection.
Make sure that the oil pressure warning indicator
comes on with the ignition switch turned t o "ON".
If the indicator does not come on, inspect as follows:
Remove the fuel tank (page 5-59).
Remove the dust cover.
Remove the screw and oil pressure switch terminal.
Short the oil pressure switch wire terminal w i t h the
ground using a jumper wire.
The oil pressure warning indicator comes o n w i t h the
ignition switch turned to "ON".
If the indicator does not comes on, check the sub-fuse
cuit.
Start the engine and make sure the indicator goes out.
If the indicator does not go out, check the oil pressure
(page 4-3).
If the oil pressure is normal, replace the oil pressure
switch (see below).
Remove the dust cover, terminal screw and wire ter-
minal.
Remove the oil pressure switch f r o m the crankcase.
19-14
OIL P R E S S U R ~ WARNING INDICATOR
or
an open cir-