Honda CBR954RR 2002 Service Manual page 231

Connect the timing light t o the
Read
wire.
for timing
operation
Start the engine and let it idle.
IDLE
SPEED: 1,200
The ignition timing is correct if the "F" mark aligns
with the index mark on the ignition pulse generator
rotor cover.
Increase the engine speed by turning the throttle stop
screw and make sure the "F" mark begins t o move
counterclockwise when the engine speed at approxi-
mately 1,500 rpm.
Check that the O-ring is i n good condition, replace if
necessary.
Apply oil t o the O-ring.
Apply grease t o the timing hole cap threads and
install the O-ring and timing hole cap.
Tighten the timing hole cap t o the specified torque.
TORQUE:
Install the lower cowl (page
direct ignition coil
rpm
18 N.m (1.8 kgf-m, 13 Ibf-ftl