Honda CBR954RR 2002 Service Manual page 163

Remove the fuel hose banjo bolt and attach the fuel
pressure gauge with the following Honda genuine
parts.
Banjo bolt, 12 mm
Parts No. 90008-PD6-010
Sealing washer, 12 mm
Parts No. 90428-PD6-003
Sealing washer, m m
6
Parts No. 90430-PD6-003
TOOL:
Fuel pressure gauge
Connect the battery negative cable.
Start the engine.
Read the fuel pressure at idle speed.
IDLE SPEED: 1,200
STANDARD: 343 kPa (3.5 kgf/cm2, 50 Psi)
If the fuel pressure is higher than specified, inspect
the following:
- Pinched or clogged fuel return hose
- Pressure regulator
- Fuel pump (page 5-57)
If the fuel pressure is lower than specified, inspect the
following:
- Fuel line leaking
-
Clogged fuel filter
- Pressure regulator
- Fuel p u m p (page 5-57)
After inspection, remove the fuel hose banjo bolt and
reinstall and tighten the original fuel hose banjo bolt
using the new sealing washers.
TORQUE: 22 N-m (2.2 kgf-m, 16
Always replace the sealing washers when the fuel
hose banjo bolt is removed or loosened.
Connect the pressure regulator vacuum hose.
Install the removed parts in the reverse order of
removal.
FUEL SYSTEM (Programmed Fuel Injection)
07406-004000A
(U.S.A. only)
SEALING WASHERS
FUEL PRESSURE GAUGE
\
SEALING WASHERS
BANJO BOLT
V
v
BANJO BOLT
5-55