Honda CBR954RR 2002 Service Manual page 206

HYDRAULIC BRAKE
Coat the new piston seals w i t h clean brake fluid.
Coat the new dust seals with silicone grease.
Install the piston and dust seal into the groove o f the
caliper body.
Coat the caliper pistons w i t h clean brake fluid and
install t h e m into the caliper cylinder w i t h their open
ends toward the pad.
Install the new joint seal into the fluid passage on the
caliper.
Assemble the caliper halves and install and tighten
the new caliper assembly torx bolts t o the specified
torque.
TORQUE:
IN STALLATION
Install the brake pads and caliper onto the fork leg
(page 15-9).
Install and tighten the new caliper mounting bolts t o
the specified torque.
TORQUE:
Install the brake hose eyelet t o the caliper body w i t h
t w o new sealing washers and oil bolt.
15-24
23 (2.3 kgf-m,
(3.1 kgf-m, 22 Ibf-ft)
TON
TORX
BOLTS