General Information; Service Rules; Model Identification - Honda CBR954RR 2002 Service Manual

SERVICE RULES

MODEL I
SPECIFICATIONS
TORQUE VALUES
TOOLS
SERVICE RULES
1 . Use genuine Honda or Honda-recommended parts and lubricants or their equivalents. Parts that do not meet Honda's
design specifications may cause damage t o the motorcycle.
2. Use the special tools designed for this product to avoid damage and incorrect assembly.
3. Use only metric tools when servicing the motorcycle. Metric bolts, nuts and screws are not interchangeable with English
fasteners.
4. Install new gaskets, O-rings, cotter
5 . When tightening bolts or nuts, begin w i t h the larger diameter or inner bolt first. Then tighten t o the specified torque
diagonally in incremental steps unless a particular sequence is specified.
6. Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.
7. After reassembly, check all parts for proper installation and operation.
8. Route all electrical wires as shown o n pages 1-23 through 1-36, Cable and Harness Routing.

MODEL IDENTIFICATION

GENERAL INFORMATION

LUBRICATION & SEAL POINTS
1-1
1-1 CABLE & HARNESS ROUTING
1-3 EMISSION CONTROL SYSTEMS
1-12 EMISSION CONTROL INFORMATION
LABELS
1-17
pins, and lock plates when reassembling.
1-19
1-23
1-37
1-40