Honda CBR954RR 2002 Service Manual page 179

INSTALLATION
Check the insulator band angle.
Apply oil to the insulator inside surfaces for ease of
throttle body installation.
Do not hold the fuel pipe on the throttle
installing the throttle body.
Tighten the insulator band so that the insulator band
distance is 12 1 m m (0.5
Do
not confuse the TP sensor connector and MAP
sensor connector; the throttle sensor connector wire
is identified by the label "TPS"
Route the injector sub-harness referring the wiring
diagram (page 1-27).
Connect the fuel injector connectors and TP sensor
connector.
Connect the No.3 injector connector pallarel to the
connector stopper.
FUEL SYSTEM (Programmed Fuel Injection)
while
body
0.04 in).
RS
I N S U LATO
5-7 1