FUEL SYSTEM (Programmed Fuel Injection)
PGM-FI MIL 8 BLINKS (TP SENSOR)
Turn the ignition switch t o "OFF".
Disconnect the TP sensor 3P connector.
Check for loose or poor contact on the TP sen-
sor connector.
Place the motorcycle on its side stand.
Start the engine and check that the MIL blinks.
Turn the ignition switch t o "OFF".
Disconnect the TP sensor 3P connector.
Turn the ignition switch t o
Measure the voltage between the wire harness
side connector terminal and ground.
Connection: Yellow/Red
-
Standard: 4.75
5.25 V
5-18
8 blinks
I
"ON".
-
Ground
(+)
Out of range
Open or short circuit in the YellowiRed wire
Loose or poor contact o n the ECM connector