Duct Cover Removal/Installation - Honda CBR954RR 2002 Service Manual

FRAME BODY PANELS/EXHAUST SYSTEM
Connect the tail light connector.
Install the rear cowl over the seat rail being careful not
to damage the wire harness.
Install the spacers, setting collars and setting bolts.
Install the special screws and truss screws.
Install the t r i m clips.
Tighten the setting bolts and special screws securely.
Tighten the screws to the specified torque.
TORQUE:
Rear cowl truss screw:
1.5 N * m (0.15 kgf-m, 1.1 Ibf-ft)
Connect the seat lock cable t o the key cylinder.
Install the pillion seat and nuts t o the pillion seat
bracket.
Tighten the nuts t o the specified torque.
TORQUE: 11 N - m (1.1 kgf-m, 8 Ibf-ft)
Push the pillion seat d o w n t o lock it.
COVER
DUCT
REMOVAL/INSTALLATION
Remove the screws.
Release the tab of the duct cover f r o m the fuel tank,
then remove the duct cover.
Installation is in the reverse order of removal.
TORQUE: 1.5 N - m (0.15 kgfem, 1.1 Ibf*ft)
2-4
SETTING BOLT
COLLAR
V
SPECIAL SCREWS
NUTS
SEAT LOCK CABLE
SCREWS
SCREWS
BRA C KET