Pgm-Fi Mil 1 Blink (Map Sensor) - Honda CBR954RR 2002 Service Manual

FUEL SYSTEM (Programmed Fuel Injection)
BLINK
PGM-FI MIL
1
Connect the MAP sensor connector.
Place the motorcycle o n its side stand.
Start the engine and check that the MIL blinks.
Turn the ignition switch t o "OFF".
I
Disconnect the MAP sensor 3P connector.
Turn the ignition switch to
Measure the voltage at the wire harness side
connector.
Connection: Yellow/Red
-
Standard: 4.75 5.25 V
Measure the voltage between the connector ter-
minals of the-wire harness side.
Connection: Yellow/Red
5-12
(MAP SENSOR)
blink
1
"ON".
-
Ground
(+)
t
-
(+)
Voltage exists
Does not blink
Loose or poor contact o n the MAP sensor connec-
tor
Out of range
Open or short circuit i n Yellow/Red wire
Loose or poor contact on the ECM connectors
Out of range
Open or short circuit in Greedorange wire
Loose or poor contact o n the ECM connectors