4
POWERDRIVE CHARGER (ONBOARD)
17
Figure 4-28 Charger DC Cord Black Wire and Blue
Wire – DS Villager 4
Onboard Charger Installation
1. Installation is reverse of removal.
2. Tighten hardware securing the black DC cord wire to 23 in-lb (2.6 N·m) and the red DC cord wire to 144
in-lb (16 N·m).
3. Install four bolts (21), flat washers (22), lock washers (23) and nuts (24) securing charger to chassis and
tighten to 108 in-lb (12 N·m) (Figure 4-27, Page 4-33).
4. Connect the batteries. See Connecting The Batteries on page 1-4.
PRECEDENT VEHICLES
Onboard Charger Removal
1. Connect the batteries. See Connecting The Batteries on page 1-4.
2. Disconnect the charger DC cord at the three pin connector (1) (Figure 4-29, Page 4-35).
3. Remove four bolts (2), flat washers (3), lock washers (4) and nuts (5) securing charger to chassis.
4. Lift charger assembly from vehicle.
Page 4-34
2008-2011 Domestic Battery Charger Maintenance and Service Manual
19
20
18
Onboard Charger Removal and Installation