Ammeter - Club Car 2008-2011 Maintenance And Service Manual

6
POWERDRIVE 3 – MODEL 26560
6. Slide the heatshrink tubing (7) over the connection and apply heat to the heatshrink to insulate the con-
nection between the AC cord white wire and the tan primary coil wire. See following WARNING.
ý
WARNING
• Make sure the electrical connections are properly insulated. Failure to properly insulate
electrical connections in the charger could result in a short circuit.
7. If equipped, replace wire tie(s) securing transformer wires. See following WARNING.
ý
WARNING
• Make sure wiring is properly routed and secured. Failure to properly route and secure wiring
could result in charger malfunction, property damage, or severe personal injury.
8. Install the charger cover and check charger for proper operation.

AMMETER

See General Warning, Section 1, Page 1-1. See additional WARNING on page 6-1.
Ammeter Removal
1. Disconnect AC cord from the wall outlet and DC plug from the vehicle receptacle.
2. Remove the charger cover.
3. Disconnect the DC cord red wire (1) and the white wires (2 and 3) from the ammeter (4) (Figure 6-25,
Page 6-31).
4. Press the locking tabs on each side of the ammeter and remove the ammeter by gently pushing the
ammeter through the front of the charger case.
Ammeter Installation
1. Place the ammeter (4) in position in the charger face and ensure that the locking tabs are secure
(Figure 6-25, Page 6-31).
2. Connect the DC cord red wire (1) and the white wires (2 and 3) to the ammeter terminals.
3. Install the charger cover.
4. Plug the charger into the vehicle and check ammeter for proper operation.
Page 6-30 2008-2011 Domestic Battery Charger Maintenance and Service Manual
Charger Repairs