Club Car 2008-2011 Maintenance And Service Manual page 156

6
POWERDRIVE 3 – MODEL 26560
AC Cord
1. Disconnect AC cord from the wall outlet and DC plug from the vehicle receptacle.
2. Remove the charger cover.
3. Disconnect the green wire (2) from charger case and position it so it does not touch any metal part of the
charger (Figure 6-22, Page 6-24).
4. Disconnect the black wire (1) of AC cord from charger AC circuit breaker (3).
5. Carefully cut the heatshrink (7) that insulates the AC cord white wire (4) where it connects to the tan pri-
mary coil wire.
7
4
6. Disconnect the AC cord white wire (4) from the primary coil tan wire.
7. Using a multimeter set for 200 ohms, place the red (+) probe on the terminal at the end of the black wire
(1). Test for continuity on each of the flat blades and then on the round pin of the AC plug (6). The tester
should indicate continuity on one flat blade only. If any other reading is obtained, the AC cord and plug
must be replaced.
8. Place the red (+) probe on the end of the green wire (2) and with the black probe check for continuity on
both flat blades and on the round pin of the AC plug (6) (Figure 6-22, Page 6-24). The tester should indi-
cate continuity on only the round pin. If any other reading is obtained, the AC cord and plug must be
replaced.
9. Place the red (+) probe on the white wire (4) and check for continuity on both flat blades and on the
ground pin of the AC plug (6). The tester should indicate continuity on only one flat blade. If any other
reading is obtained, the AC cord and plug must be replaced.
10. If the correct readings were obtained, install the AC cord. See AC Cord Installation on page 6-33.
Page 6-24 2008-2011 Domestic Battery Charger Maintenance and Service Manual
5
2
Figure 6-22 AC Cord and Plug Continuity Test
3
1
6
Test Procedures
WAVETEK 5XL
V V
OFF
1000 500
200 200
20
200
2 2m
200 20
m
m
200
2000
m
k
200k
20k 200
2k A
! COM ! 200nA
V
MAX
1000 ---
FUSED
750V
200 OHM SETTING