Club Car 2008-2011 Maintenance And Service Manual page 259

IQ PLUS CHARGER (ONBOARD)
2. Remove the charger cover.
3. Disconnect the DC cord black wire (5) and the buss bar (3) from the ammeter (Figure 9-18, Page 9-25).
4. Remove the two nuts (2) that secure the ammeter to the charger face.
5. Remove the ammeter from the face of the charger.
5
4
Figure 9-18 Ammeter
Ammeter Installation
1. Place the ammeter in position in the charger face (Figure 9-18, Page 9-25).
2. Install nuts (2) and tighten until ammeter is firmly secured.
3. Connect the black wire (5) of the DC cord to the left (as viewed from inside the charger) post of the amme-
ter.
4. Connect the buss bar (3) from the fuse link to the right post of the ammeter. Place flat washers on both
sides of the buss bar.
5. Thread nuts (4) onto both posts of ammeter until just past finger tight. While holding the inside nut, tighten
the outside nut (4) 1/4 turn. See following CAUTION.
CAUT ION
• Do not allow ammeter post to rotate as the nut is tightened. Rotation of the post could result
in a damaged ammeter.
6. Install the charger cover and install the charger in the vehicle. See Onboard Charger Installation on
page 9-31.
7. Check charger for proper operation.
2
1
3
2008-2011 Domestic Battery Charger Maintenance and Service Manual
9
Charger Repairs
Page 9-25