POWERDRIVE 3 – MODEL 26560
FUSE LINK
See General Warning, Section 1, Page 1-1. See additional WARNING on page 6-1.
Fuse Link Removal
1. Disconnect AC cord from the wall outlet and DC plug from the vehicle receptacle.
2. Remove the charger cover.
3. Gently press the fuse toward the transformer to remove the fuse from the mounting tab.
4. Remove the two nuts securing the two wires to the fuse terminals and remove the fuse.
Fuse Link Installation
1. Connect the short brown wire from the rectifier to one of the fuse terminal posts and install the nut.
Tighten nut to 23 in-lb (2.6 N·m).
2. Connect the DC cord black wire to the other fuse terminal post and install the nut. Tighten nut to 23 in-
lb (2.6 N·m).
3. Gently press the fuse assembly into the mounting tab so that the fuse link is visible from the rear of the
charger.
4. Install the charger cover.
Figure 6-25 Ammeter
2008-2011 Domestic Battery Charger Maintenance and Service Manual
Charger Repairs
4
2
3
6
1
Page 6-31