Club Car 2008-2011 Maintenance And Service Manual page 45

POWERDRIVE CHARGER (EXTERNAL)
ý
WARNING
• Do not bypass the sense lead fuse.
3.4. Remove the gray sense lead fuse and check it for continuity with a multimeter set to 200 ohms. The
resistance should be less than 2 ohms.
3.5. Precedent: Verify that the 10-gauge red wire from the charger receptacle is connected to the pos-
itive (+) post of battery no. 1 (Figure 3-4, Page 3-5, Figure 3-5, Page 3-6 and Figure 3-6,
Page 3-7).
4. Check battery pack voltage.
4.1. DS, DS Villager 4, 800, 810 and 850: With a multimeter set to 200 volts DC, measure the voltage
of the battery pack between the positive (+) post of battery no. 1 and the negative (–) post of battery
no. 4 (Figure 3-12, Page 3-17).
FRONT
OF VEHICLE
4
Figure 3-12 DS, DS Villager 4, 800, 810 and 850
Battery Voltage Test
4.2. Turf 1 and Carryall 1: With a multimeter set to 200 volts DC, measure the voltage of the battery
pack between the positive (+) post of battery no. 1 and the negative (–) post of battery no. 6
(Figure 3-13, Page 3-17).
1
2
3
FRONT
OF VEHICLE
4
5
Place multimeter
6
black (–) probe here.
Figure 3-13 Turf 1 and Carryall 1 Battery Voltage Test
2008-2011 Domestic Battery Charger Maintenance and Service Manual
Place multimeter
red (+) probe here.
2
3
1
3
Test Procedures
Page 3-17