Club Car 2008-2011 Maintenance And Service Manual page 74

Domestic powerdrive, iq plus and high frequency battery chargers
Table of Contents

Advertisement

4
POWERDRIVE CHARGER (ONBOARD)
TEST PROCEDURE 1 – BATTERY VOLTAGE
See General Warning, Section 1, Page 1-1.
Test Procedure 1A – DS Villager 4
1. Check the wire connections between the vehicle and battery charger (Figure 4-2, Page 4-3).
1.1. Verify that the 10-gauge red wire of the charger is connected to the positive (+) post of battery no. 1.
1.2. Verify the connection of the 10-gauge black wire from the onboard computer and the 10-gauge
black wire from the battery charger at the fuse link on the charger receptacle.
1.3. Check the connections of the DC cord blue wire (17), from the charger, and the gray wire, from the
onboard computer, to the the 3-way wire adapter (18) (Figure 4-28, Page 4-34). See following
WARNING.
ý
WARNING
• Do not bypass the sense lead fuse.
1.4. Remove the gray sense lead fuse and check it for continuity with a multimeter set to 200 ohms. The
resistance should be less than 2 ohms.
2. With a multimeter set to 200 volts DC, measure the voltage of the battery pack between the positive (+)
post of battery no. 1 and the negative (–) post of battery no. 4 (Figure 4-5, Page 4-10). Normal no-load
voltage should be between 50 and 52 volts for fully charged batteries. The voltage of the battery pack
must be over 34 volts DC to allow the onboard computer to close the charger relay. If battery pack voltage
is too low to start charger, temporarily bypass the charger relay. See Charging a Battery Pack that has
Low Voltage on page 4-31.
OF VEHICLE
Figure 4-5 Battery Voltage Test –
Test Procedure 1B – Precedent Vehicles
1. Check the wire connections between the vehicle and battery charger (Figure 4-3, Page 4-3).
1.1. Verify that the 10-gauge red wire of the charger is connected to the positive (+) post of battery no. 1.
1.2. Verify the connection of the 10-gauge black wires in the charger adapter harness. One wire con-
nects to the onboard computer black lead wire. The second wire connects to the charger receptacle
black lead wire.
Page 4-10
2008-2011 Domestic Battery Charger Maintenance and Service Manual
FRONT
2
3
4
DS Villager 4
1
Test Procedures

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents