HIGH FREQUENCY CHARGER (ONBOARD)
HOW TO IDENTIFY CHARGE ALGORITHM NUMBER
The algorithm numbers offered can be found in Battery Charger Identification on page 2-1. The charger
can display its algorithm number by initiating Algorithm Display Mode. To enter Algorithm Display Mode, do
the following:
1. Unplug the AC power supply cord from the wall outlet.
2. Disconnect the heavy-gauge red wire from the positive (+) post of battery no. 1.
3. Plug the AC power supply cord into the wall outlet. See following NOTE.
NOTE: When the charger AC cord is connected, LED lights on the charger and dash perform start-up self-
test (LEDs light up in sequence).
4. After the start-up self-test, the 80% LED will display a series of flashes that represent the algorithm num-
ber (Figure 10-2, Page 10-3). [Example: Algorithm number 125 is represented as "one flash", pause,
"two flashes", pause, "five flashes".] The charger will not repeat this series of flashes. To see the number
again, repeat steps 1 and 3 with a 20 second pause between them.
Figure 10-2 80% LED Flashes in Algorithm Display
Mode
2008-2011 Domestic Battery Charger Maintenance and Service Manual
10
General Information
Page 10-3