Mounting To A Wall Or Building Corner - Mobotix D24M Manual

88
/133
D24 Camera-Manual: InSTALLATIOn

2.10.4 Mounting To A Wall Or Building Corner

Use the supplied screw anchors, screws and washers to affix the Corner and Pole Mount
to a building corner.
• Mark the four screw anchor holes on the corner of the
building, ensuring that the arrows on the mount point
upwards. Drill the holes with a 10 mm wall drill.
• Pass the on-site network cable through one of the large
round holes at the back of the Corner and Pole Mount,
then through one of the 16 mm diameter holes on the
front of the mount. In order to properly protect the cabling,
you should let the cabling run from the inside of the
building through the Corner and Pole Mount directly
into the camera (concealed cabling). note: The cable
length from the building corner should be at least
80 cm!
• Place the included wall anchors in the drilled holes
and screw the Corner and Pole Mount into place on
the corner of the building using the Torx screws and
washers. Use the supplied drilling template (fold-out
at the end of this manual) to mark the exact positions
for the drill holes.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com