Procedure For D24M It/Secure - Mobotix D24M Manual

D24 Camera-Manual: InSTALLATIOn

2.5.4 Procedure For D24M IT/Secure

Install and prepare the network connection
1. Install and prepare
2. Install the flush-mounted socket: nstall the flush-mounted
must be connected with the on-site network cable. For installation without acces- must be connected with the on-site network cable. For installation without acces-
sories, a flush-mounted socket must be installed first to provide space for the con- sories, a flush-mounted socket must be installed first to provide space for the con-
nection. The cabling is now perfectly protected and cannot be seen or accessed nection. The cabling is now perfectly protected and cannot be seen or accessed
from the outside. The camera cannot be mounted directly on top of protruding, from the outside. The camera cannot be mounted directly on top of protruding,
surface-mounted sockets. Use the supplied camera drilling template (fold-out at surface-mounted sockets. Use the supplied camera drilling template (fold-out at
the end of this manual) to mark the position of the flush-mounted socket for the the end of this manual) to mark the position of the flush-mounted socket for the
desired camera position.
3. Drill the holes: Drill the holes for the supplied screw anchors (see drilling template).
4. Connect the cable: Connect the on-site network cable to the camera patch cable
using a standard connector.
5. Attach the camera: A Attach the camera:
camera at the designated position.
6. The outer shell is required at a later stage in the installation and is attached only
when the dome has been removed and placed back after a lens adjustment.
7. Proceed to Section 2.11, Aiming And Adjusting The Lens.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
socket:The pre-installed cable attached to the camera The pre-installed cable attached to the camera
Use the (included) screws to affix the mounting ring and the
57
/133