Procedure - Mobotix D24M Manual

64
/133
D24 Camera-Manual: InSTALLATIOn

2.6.3 Procedure

1. Attach washers: Prior to installation, stick a black foam
rubber washer around each of the four screw holes on
the rear side of the on-wall housing (remove the adhesive
foil and press into place, surface must be clean and free
of grease). This prevents water from entering the housing.
2. Prepare the cabling: Insert the seal into the cable
opening of the On-Wall Set such that the black rubber
seal is on the outside. Fix it in place from the inside
using a small hexagonal nut.
3. Mount the On-Wall Set: Mount the On-Wall Set (with-
out the camera) at the intended position using the Torx
screws (included with D24M camera, items 1.10 – 1.12).
4. Cable feeding: Attach the counter nut to the network
cable, pass it through the seal from the outside and
tighten the nut. The network cable is now screwed into
the On-Wall Set, weatherproof. All unused openings
must be sealed with the included sealant plugs. The
cable passing into the housing must always be installed
using the supplied three-part fittings.
5. Remove the camera outer shell: Remove all four Allen
screws with the supplied Allen wrench and lift off the
outer shell (not mounted upon delivery).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com