Power Supply Using A Switch - Mobotix D24M Manual

D24 Camera-Manual: InSTALLATIOn
The MOBOTIX factory default is Class 2. This default is usually fine and nothing needs
to be changed. However, if the lower power level Class 1 is sufficient for your application,
it may be advantageous – due to possible internal power distribution schemes amongst
the ports of the PoE switch in use – to change the PoE power level class in the browser:
1. Select Admin Menu > network Setup > Ethernet interface
(for experts).
2. Under Power Supply, click Change.
3. A Power Wizard will appear to guide you through the PoE
configuration steps.
4. The camera will then need to be restarted via a hard reboot:
Disconnect the camera from the power supply, then recon- Disconnect the camera from the power supply, then recon- Disconnect the camera from the power supply
nect it, for example, by disconnecting and then reconnecting
the network cable at the PoE switch.

2.13.3 Power Supply Using A Switch

1. Connect the factory pre-installed cable of the
camera to the Camera connector of the Network Power Adapter.
2. Connect the LAn/Power connector of the NPA to the switch/router or the Ethernet Power connector of the NPA to the switch/router or the Ethernet Power
socket using an Ethernet connector.
3. Plug the RJ45 connector of the external power unit into the PC/Power connector
of the Network Power Adapter.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
PC/Power PC/Power connector
95
/133
Variable PoE: multiple
cameras can be oper-
ated simultaneously
from the same switch
The IP addresses in
the diagram are shown
only as an example
For the D24M, you
should use the new
blue MX-NPA-PoE-Set
- previous MOBOTIX
network power acces-
sories such as the NPA
Set, Power Box and
Power Rack (MX-NPA-
Set, MX-NPR-4 and
MX-NPR8/20) are
not suitable for use
with the D24M