Mobotix D24M Manual page 83

D24 Camera-Manual: InSTALLATIOn
5. Mount the Wall Mount (without camera): Stick the
black wall sealing to the back of the Wall Mount (remove
the adhesive foil first, the surface must be clean and
free of grease). Pass the network cable through the
large square opening and into the Wall Mount. Use
the included screws to install the Wall Mount (without
the camera) at the intended position. Pass the network
cable through the large square opening on back side
of the Wall Mount.
6. Connect the cable: Prepare the on-site network cable
for connection with the camera patch cable using a
standard connector. Excess cable can be stored easily
within the Wall Mount.
7. Install the bottom plate with the camera in the Wall
Mount: Connect the camera patch cable to the network
cable. Then mount the bottom plate with the camera
in the slots from below and fix it in place on the Wall
Mount using the 4 Allen screws (Allen wrench included).
8. Proceed to Section 2.11, Aiming And Adjusting The Lens.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
83
/133