Mounting To The Corner Of A Building - Mobotix D16 DualDome Manual

Mounting the Corner and Pole Mount

2.5.2 Mounting to the Corner of a Building

Use the supplied screw anchors, screws and washers to affix the Corner and Pole Mount
to a building corner.
1. Mark the four screw anchor holes on the corner of
the building. Make sure that the arrows on the mount
are pointing upwards. Drill the holes with a 10-mm
drill bit.
2. Guide the connection cables through one of
the large round holes at the back of the Corner
and Pole Mount and then through one of the two
16-mm holes on the front of the mount. In order to
properly protect the cabling, you should let the
cabling run from the inside of the building through
the Corner and Pole Mount direc tly into the cam-
era. Note: The cable to the camera should be at
least 80 cm from the corner!
3. Insert the supplied 10-mm screw anchors into the screw anchor holes and secure
the Corner and Pole Mount to the corner of the building using the 8x70 screws and
washers (diam. 9 mm).
Attach the Outdoor Wall Mount to the Corner and Pole Mount as described in Section 2.5.4,
«Mounting the Outdoor Wall Mount».
Make sure that the arrows
are pointing upwards
when mounting
Make sure not to pinch
and damage the cables
when mounting
53