Camera Startup Sequence - Mobotix D24M Manual

D24 Camera-Manual: InSTALLATIOn

2.13.6 Camera Startup Sequence

As soon as the camera's power supply has been established, the two LEDs will show the
progress of the startup sequence (see Section 5.4.3 LED Signals and LED Configuration
in the Software Manual ).
• Startup sequence: Immediately after connecting the power supply, the red LED lights
up, blinks for two seconds, then stays on permanently. The camera's boot loader
checks the hardware, unpacks and starts the operating system. Next, the camera
checks all of its applications for errors. In case of an error, the camera will start
using the backup operating system. Afterwards, both LEDs light up for four seconds.
• Waiting for key pressed: Both LEDs light up for four seconds. If you press the R or
L key of the camera during this time, the camera will execute the corresponding
function (see Sections 3.2.5 and 3.2.6).
• Ready: Once the camera software has been started, the green LED is on permanently
and the red LED blinks. You can now reach the camera via the network using a
browser.
Key L
LEDs (1 x green, 1 x red)
During the startup sequence of the camera, the LEDs will always light up, even if
they have been deactivated in Admin Menu > LED Setup.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Key R
Notes
97
/133
1. Start
2. Key?
3. Ready