Mounting To A Pole - Mobotix D24M Manual

D24 Camera-Manual: InSTALLATIOn

2.10.3 Mounting To A Pole

Use the supplied stainless steel straps to affix the Corner and Pole Mount to a pole.
• Guide the supplied stainless steel straps through the
openings in the Corner and Pole Mount as shown in
the diagram. Make sure that you are using the slots of
the mount that best fit for the thickness of the pole. The
stainless steel straps allow attaching the mount to poles
with diameters between 60 and 180 mm.
• Guide the on-site network cable from behind through
one of the large round holes of the Corner and Pole
Mount. In order to properly protect the cabling, it is best
to pass the cabling from the inside of the pole through
the Corner and Pole Mount directly into the camera
(concealed cabling). note: The cable length from the
pole should be at least 80 cm!
• Tighten the stainless steel straps on the Pole Mount
with a screwdriver. If necessary, the ends of the straps
can be cut off.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
87
/133