Installing The Wall Mount; Mounting Instructions - Mobotix D24M Manual

78
/133
Direct installation over
surface- and flush-
mounted sockets
D24 Camera-Manual: InSTALLATIOn
2.9

Installing The Wall Mount

2.9.1 Mounting Instructions

The Wall Mount allows you to easily mount D24M cameras to walls or extensions, both The Wall Mount allows you to easily mount D24M cameras to walls or extensions, both
indoors or outdoors. The camera remains IP65 weatherproof (dust-proof and resistant indoors or outdoors. The camera remains IP65 weatherproof (dust-proof and resistant
to water jets). The Wall Mount also covers RJ45 flush-mounted sockets and has ample to water jets). The Wall Mount also covers RJ45 flush-mounted sockets and has ample
space for additional modules (Mx2wire, WLAN, batteries, etc.). space for additional modules (Mx2wire, WLAN, batteries, etc.).
Before mounting Before mounting
the MOBOTIX D24M with the Wall Mount, you must prepare the network the MOBOTIX D24M with the Wall Mount, you must prepare the network
connection and drill the holes for the fixtures: connection and drill the holes for the fixtures:
• The on-site network cabling on-site network cabling is passed through the opening
in the back of the Wall Mount. The cable and the required in the back of the Wall Mount. The cable and the required
(standard) connector for the camera cable (patch cable) are (standard) connector for the camera cable (patch cable) are
ideally protected by a robust wall sealing made from foam
rubber. Nothing is visible or accessible from the outside. The
Wall Mount may be mounted directly on top of surface- or
flush-mounted sockets. Maximum width x height of the
socket: 88 mm x 80 mm.
• Only use the factory installed patch cable of the D24M (50 cm cable length) or a
MOBOTIX cable that is available as an accessory in various lengths.
• All openings of the camera housing need to be properly sealed. This is the only way
to guarantee that the camera remains weatherproof.
• The supplied screw anchors should be used for the drill holes in the wall. Use the
drilling template for the D24M Wall Mount (fold-out at the end of this manual) to
mark the exact position for the drill holes and the holes through which the cables
will later be fed.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com