Procedure - Mobotix D24M Manual

82
/133
D24 Camera-Manual: InSTALLATIOn

2.9.3 Procedure

1. Remove the camera mounting ring: Separate the black
mounting ring from the camera housing. This ring is not
required when mounting the camera to the Wall Mount. If
the D24M was not in its original packaging, then it may be
necessary to remove the outer shell with the four Allen
screws beforehand.
2. Separate the bottom plate form the Wall Mount: The
bottom plate is used to hold the camera and is only
attached and screwed into place during a later step.
3. Pass the camera cable up through the bottom of the
bottom plate: Ensure the orientation is correct. The
spring clips should be on the underside of the bottom
plate.
4. Snap the camera into place on the bottom plate: Firmly
push the camera into the Wall Mount. The plastic spring
clips will snap into place when the trapezoidal elements
on the rear of the camera housing exactly match up
with the corresponding openings on the Wall Mount.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com