Mounting To A Wall Or Building Corner - Mobotix Q24M User Manual

98
/164
Q24M Camera Manual: Installation

2.9.4 Mounting To A Wall Or Building Corner

Use the included screw anchors, screws and washers to affix the Corner and Pole Mount
to a building corner.
• Mark the four screw anchor holes on the corner of the
building, ensuring that the arrows on the mount point
upwards. Drill the holes with a 10 mm wall drill.
• Pass the on-site network cable through one of the large
round holes at the back of the Corner and Pole Mount,
then through one of the 16 mm diameter holes on the
front of the mount. In order to properly protect the
cabling, you should let the cabling run from the inside
of the building through the Corner and Pole Mount
directly into the camera (concealed cabling). Note: The
cable length from the building corner should be at
least 80 cm!
• Place the included wall anchors in the drilled holes
and screw the Corner and Pole Mount into place on
the corner of the building using the wood screws and
washers. Use the supplied drilling template (fold-out
at the end of this manual) to mark the positions for
drilling the holes.
• Then: Install the Wall Mount on the Corner and Pole
Mount (section 2.9.5).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com