Aiming And Adjusting The Lens - Mobotix D24M Manual

90
/133
D24 Camera-Manual: InSTALLATIOn

2.11 Aiming And Adjusting The Lens

Establishing A Connection To The Camera
• Establish a connection to the camera as described in Section 3.2 First Images And
The Most Important Settings .
Aiming And Adjusting The Lens, Visual Inspection
Make sure that you see the live image of the camera on the monitor of your computer or
laptop. Now adjust the lens mount until you see the desired image area on your monitor:
• Remove the camera dome. Use the supplied plastic foil
or a cotton cloth to remove the dome by turning it in a
counter-clockwise direction. With IT/Secure models, you
may have to remove the outer shell first.
• Loosen the toothed ring slightly by turning it in a counter-
clockwise direction using the supplied hook wrench. In
addition, loosen the two Allen screws on both sides of the
lens mount slightly by turning them in a counter-clockwise
direction using the supplied Allen wrench.
Loosen the ring and screws until you are still able to pan
and rotate the internal part of the camera with the lens
without much force but not so far that the lens is unable
to move on its own.
• Now aim the camera by rotating and panning the lens
mount (Note: the MicroSD card slot must point downward
for the camera's live image to be displayed properly). Never
use force when adjusting the direction of the camera, as
this could damage the camera beyond repair.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com