Mounting To The Corner Of A Building - Mobotix D15 Manual

Mounting the Corner and Pole Mount

2.5.2 Mounting to the Corner of a Building

Use the supplied screw anchors, screws and washers to affix the Corner and Pole Mount
to a building corner.
1. Mark the four screw anchor holes on the corner
of the building. Make sure that the arrows on the
mount are pointing upwards. Drill the holes with
a 10-mm drill bit.
2. Guide the connection cables through one of
the large round holes at the back of the Corner
and Pole Mount and then through one of the two
16-mm holes on the front of the mount. In order
to properly protect the cabling, you should let
the cabling run from the inside of the building
through the Corner and Pole Mount directly into
the camera. Note: The cable to the camera
should be at least 80 cm from the corner!
3. Insert the supplied 10-mm screw anchors into the screw anchor holes and secure
the Corner and Pole Mount to the corner of the building using the 8x70 screws and
washers (diam. 9 mm).
Attach the Outdoor Wall Mount to the Corner and Pole Mount as described in Section 2.5.4,
«Mounting the Outdoor Wall Mount» .
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
65
/112
Make sure that the
arrows are pointing
upwards when mounting
Make sure not to
pinch and damage the
cables when mounting